Dinamap Pro 100V2 Spécifications télécharger pdf (Page 38)

Pulse rate derived from SpO

appears in the Pulse Rate

window, and the SpO

pulse indicator flashes

synchronization with the real-time pulse rate measurements

that are derived from the SpO

signal. A tone sounds at a

rate corresponding to the pulse rate and at a pitch

corresponding to the SpO

saturation level. The pitch is

highest at 100% oxygen saturation, and it becomes lower as

the saturation level falls. The Monitor displays a pulse bar

graph. The pulse bar graph is proportional to the signal

quality. The artifact indicator LED (24) illuminates when low

perfusion or poor signal quality is detected.

Audible and visible alarms occur when SpO

levels are

outside the alarm limits. When a limit alarm occurs, an alarm

message appears in SpO

window.

Note: Limit alarms, printing, and trending are not available

for the first 10 seconds of SpO

monitoring.

If you select the Alarms button, the Alarms menu appears.

This menu is used to adjust the violation limits for BP and

SpO

. Refer to “Alarms Button” in the “Using the Menu

System” section.

If you select the Suspend button, the SpO

alarm is

suspended for 2 minutes and then the PRO Monitor returns

to normal SpO

monitoring. A message informing the user

that SpO

is suspending appears in Area 2 and dashes

appear in the SpO

LED while the SpO

alarm suspend is

counting down. Selecting Cancel will cancel the SpO

alarm

suspension and return to monitoring SpO

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 107 108

Pas de commentaire

Dinamap Pro 100V2 Spécifications Page 38