Dinamap Pro 100V2 Spécifications télécharger pdf (Page 37)

Using the Monitor

• If the probe tip temperature is 92.0° F or higher (33.3° C)

when taken out of the probe holster, the thermometer

will not be able to perform a predictive measurement.

Instead, the thermometer will automatically go into

monitor mode. The temperature reading will then flash.

A correct final temperature reading may require 3

minutes or longer. The Monitor will not beep at final

temperature. It will continue to monitor the patient’s

temperature until the probe is removed from the patient

and returned to the probe holster.

Masimo Set* SpO

Description

The SpO

parameter in the PRO Monitor is available in two

different leading technologies: NELLCOR

OxiMax™ and

MASIMO SET

. Please refer to the front of your PRO

Monitor to see which SpO

technology your monitor

contains. The SpO

technology logo will be on the front

fascia. This section refers to MASIMO SET

SpO

technology.

The SpO

parameter is included in Models 300V2 and

400V2. To begin SpO

monitoring, simply place the SpO

sensor on the patient’s finger; monitoring begins

automatically. Functional oxygen saturation (SpO

) of arterial

blood is noninvasively and continuously monitored in the

PRO Monitor using pulse oximetry technology from

MASIMO SET

. Functional SpO

is the ratio of oxygenated

hemoglobin to hemoglobin that is capable of transporting

oxygen. This ratio, expressed as a percentage, is shown in the

SpO

window, which is continually updated.

*Masimo SET

is a trademark of Masimo Corporation. Possession or

purchase of this device does not convey any express or implied license to

use the device with replacement parts which would, alone, or in

combination with this device, fall within the scope of one or more of the

patents relating to the device.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 107 108

Commentaires sur ces manuels

Pas de commentaire

Dinamap Pro 100V2 Spécifications Page 37

Commentaires sur ces manuels